Daily Management Of Rolling Oil For Aluminum Foil Rolling Mill

- Nov 06, 2019-

Aluminum foil rolling oil plays an important role in the normal operation of the aluminum foil rolling mill. Therefore, the preservation of this oil is very important, so how to preserve this oil? As described below.

 

(1) Rolling oil should be filtered before each shift and must not be started during the filtration process. At the same time, dirty oil should be avoided in production.

 

(2) When adding base oil due to insufficient oil, the specified additives and additives should be added in proportion. Additives should normally be added to the neat tank. If added to the machine, it should be added slowly while the filtration system and cooling system are running to reduce additive filtration losses and to avoid excessive filtration pressure increases.

 

(3) To grasp the oil level in the fuel tank, please avoid the fuel tank's oil level is lower than the pump oil port. When the oil level is lower than the pump port, the pump will draw in air, but the flow rate of the injector cannot be fully controlled, which can easily cause foil fluctuations. Or the surface is not good, it will also shorten the service life of the pump.

Aluminum foil rolling oil plays an important role in the normal operation of the aluminum foil rolling mill. Therefore, the preservation of this oil is very important, so how to preserve this oil? As described below.

 

(4) The temperature of rolling oil has a close relationship with the viscosity of oil and the strength of oil film. The temperature of oil has an effect on the surface gloss, surface quality and rolling process parameters of aluminum foil. Control of coarse, medium and fine rolling oil The temperatures vary. The rough rolling oil temperature is 30-40 ° C, the medium rolling is 40-50 ° C, and the finishing rolling is 50-60 ° C.

(5) The analysis report of each rolling oil should be carefully analyzed. If abnormalities are found, measures should be taken in time and the rolling oil should be replaced if necessary.

(6) Regularly clean the rolling oil tank and double oil tank to remove deposits deposited on the bottom of the tank.

The HTMM Group will control the temperature of the rolling oil in strict accordance with the regulations, and regularly clean the rolling oil tank and the double oil tank to remove deposits deposited on the bottom of the tank.  high quality aluminum foil for our customers, customer satisfaction is our goal.